Boats, RVs and Home
This model WaterFixer uses a 3 stage
system that delivers water at 4 gallons
STAGE 1 - A five micron (5.0) pre-filter removes
particles larger than 1/5000 of an inch
STAGE 2 - A half micron (0.5) filter removes fine
sediment, odors, unpleasant tastes,
chlorine and other chemicals, plus
Cryptosporidium and Giardia cysts.
STAGE 3 - A Stainless Steel Ultra-violet Light Exposure
Chamber destroys bacteria, viruses,
protozoa, yeast, mold spores and algae.
NO CHEMICALS USED...
Like Mother Nature, the Waterfixers ultraviolet high intensity lamp provides the same germ destroying
protection as that produced by sunlight.
The Model 1000 WaterFixer delivers
water at 4 gallons per minute. This means you will experience
normal water flow.
NO WASTED WATER...
Since the WaterFixer does not require
flushing for water delivery, no water is wasted using the WaterFixer system.
NO SEPARATE WATER TANK...
With the WaterFixers method of ultraviolet
sterilization, you receive clean, clear water without the need of a separate holding tank.
NO DANGER FROM INFECTION...
Unlike reverse osmosis, the WaterFixer does not
store unprotected water. The ultraviolet chamber kills germs which may grow in
NO SPECIAL TOOLS...
Easy installation requires very little time and common household
WE CARRY ALL Filters and
See "How it Works" Page for Ultra Violet
Disinfection Information & Diagram.
1000-12V: 12 Volt DC
1000-120V: 120 Volt AC 60 HZ
1000-220V:-240 Volt AC 50 or 60 HZ
Weight: 19 lbs
Flow Rate: 4 GPM (US)
Maximum Pressure: 125 PSI
Very simple to install. For maximum effectiveness, you install as close to point of use as
possible. Simply break into water line and connect incoming line to prefilter 1/2"
NPT opening, then connect "outflow" to other end of water line. Plug the 120V
into any grounded 120V outlet or wire the 12V to your 12V power circuit.
Click on Installation
for PDF Instructions